Recently I printed a case for my new PiDrive so it can be pair easily with my Raspberry Pi. The build went pretty well, but near the “tail” of the enclosure it lifted a bit from the build plate. Also, there’s some lengthwise cracks that start at the tail. I might add some dummy parts near the tail to combat this if I were to build it again. It was printed on a Zotrax M200 using 1.75mm ABS filament. The source files can be found here.
Great blog you have here but I was curious about if you knew of any
forums that cover the same topics talked about
in this article? I’d really love to be a part of online community where I can get feedback from other
experienced people that share the same interest. If you have any
suggestions, please let me know. Bless you!